Dryer Vent Cleaning: Water in the Vent Line


I met with an Owner at one of the possessions exactly the other day who had a major water issue with his drier vent line. After meeting the Owner, he chose me to his basement and opened up a closet. That was a elastic dryer hose hanging right in front of the head in a major U formation. The dog owner explained,”I think there is certainly water .” Obviously, this can be the reason why his employees were experiencing problems drying their apparel.

I caught the nozzle , jostled it back and forth, and also the noise of plain water made a whooshing sound, it felt as though that there had been two gallons of plain water in the port line. The weight of such a large sum of water caused the duct line to overeat into a few feet above a floor. Providentially, the hose did break and lead to water damage and mold all over the ground.

I believed to the home clean dryer vent,”The builder must have already been very lazy due to the fact he should not ever of put in such a kind of flexible dryer port line in the partitions. He should’ve installed on the metal kind of drier duct.” Regrettably, contractors occasionally set up the flexible transparency kind of duct line from walls, and also are even known to some times depart the drier

to attics which is incredibly harmful.

When a elastic port is installed rather than the stiff metallic form, if there is only a tiny water condensation from drying clothes, then this warm water could develop and start to melt the port line. And when the duct lineup jelqing, it merely hastens an increasing number of water. Unfortunatelythe drinking water will totally clog the port line when it sags, and completely obstruct the warmth. If there is definitely an airflow congestion due to drinking water buildup, it can seriously harm a drier and make even a powerful new drier useless.

Sometimes, the drinking water can also come out of the exterior once the outdoor protect isn’t sealed properly and rainwater pops in to the dryer duct. The easy solution to this will be to secure the external port cover using clear caulk or to install a fresh bathtub. The exterior vent cap for the homeowner was under a over-hang wherever rain would not reach it, so the drinking water has been unquestionably coming out of his outfits. Commonly, drinking water condensation in the line isn’t a problem, but since he had a flexible hose inside the walls, the smallest quantity of water compelled it to melt and snare an increasing number of drinking water.

I caught a big plastic bucket, then placed it below the sagging port line, took a pen, and then hauled it with a hole. It almost felt like a surgical procedure. The water gushed from the duct line and also into the skillet along side a blend of lint. Once all of the water drained, I only recorded the hose up using vent tape.

After mending the water problem, I went about my usual cleaning procedure and slit out the vent line by the inside, set my mill within the port line, and proceeded to sweep it out of the surface of More line pulled out, and the airflow resumed in the port line also has been blowing off outside sturdy.

No comments yet

leave a comment